Table of Contents
Advertisement
Instructions/ 安全指示
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near the equip-
ment and must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall may cause damage.
7.
For rack-mount equipment, please firmly install the device with pallets or sliding
rails in the rack.
8.
Do not leave this equipment in an environment unconditioned where the storage
temperature under 0
equipment.
9.
The openings on the enclosure are for air convection. Protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
10.
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
11.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
12.
All cautions and warnings on the equipment should be noted.
13.
If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
14.
Never pour any liquid into an opening. This may cause fire or electrical shock.
15.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
16.
If one of the following situations arises, get the equipment checked by service
personnel:
The power cord or plug is damaged;
Liquid has penetrated into the equipment;
The equipment has been exposed to moisture;
The equipment does not work well, or you cannot get it to work according to
the user's manual;
The equipment has been dropped and damaged;
The equipment has obvious signs of breakage.
17.
CAUTION: The computer is provided with a battery-powered real-time clock cir-
cuit. There is a danger of explosion if battery is incorrectly replaced. Replace
only with same or equivalent type recommended by the manufacture. Discard
used batteries according to the manufacturer's instructions.
18.
THE COMPUTER IS PROVIDED WITH CD DRIVES COMPLY WITH APPRO-
PRIATE SAFETY STANDARDS INCLUDING IEC 60825.
°
°
C (32
F) or above 40
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
iii
°
°
C (104
F), it may damage the
HPC-7485 User Manual/ 用户手册
Advertisement
Table of Contents
