Table of Contents
Advertisement
11-2. U ni t i ni ti a l set ( I ni ti a l setti ng s f or th e c onnec ted u ni ts)
Make the initial settings for each of the connected units using " Main menu" > " Service" > " Unit initial set" . Change
the settings as necessary.
Procedures
1. Select " Unit initial set" in the Service menu and press the [ Select] button.
2. If the connected unit is running, a message requesting a system shutdown
appears. Press the [ F3] button to shut down the system.
The Unit initial set menu will be displayed.
[ 1] U ni t S etti ng ( D eta i l setti ng s f or th e c onnec ted u ni ts)
Determine the initial values for the connected unit control parameters based on the installation locations and set
the values.
Item
Day Start Time
Minimum V olume
Heating unit
Procedures
1. Select " Unit setting" in the Unit initial set menu and press the [ Select]
button.
Once data acquisition is completed, the current settings will be shown.
2. Press the [ F1] or [ F2] button to select the item to be changed and then use
the [ F3] or [ F4] button to change the setting to the desired value.
3. After setting the value, press the [ Select] button.
* This function may not function depending on the unit model.
[ 2] F u nc ti on setti ng
Sets the functions for each connected unit as necessary from the remote
controller.
Refer to the Instruction Book for information on the procedure.
WT08011X 02
Sets the times at which graph data is collected for each day (12: 00/22: 00/0: 00).
Sets the minimum amount of hot water to be retained when the storage level is declining.
Sets the number of heat source units running concurrently during heating operation.
Description
22
Unit1
FRI
System shut down?
N o
Y es
Unit1
FRI
Unit initial set
Unit Setting
Function setting
Unit1
FRI
Unit Setting
Day Start Time
--
Minimum V olume
--
Heating unit
Unit1
FRI
Function setting
M-NET address
Function No.
Data
Function
Set
Conf
Advertisement
Table of Contents
