Table of Contents
Advertisement
1. HOW TO INSTALL THE SYSTEM
1.2.2
Bulkhead mount
1. Drill four pilot holes in the mounting location for mounting screws (M6 bolts or
coach screws φ6), referring to the outline drawing at the back of this manual.
2. Screw two mounting screws (supplied locally) into the lower pilot holes. Leave 5
mm of thread visible.
3. Set the notches of the unit onto the screws fastened at step 2.
4. Screw two mounting screws (supplied locally) into the upper fixing holes.
5. Fasten all screws tightly to secure the unit in place.
Mounting screw
(M6 bolt, coach
screw Ø6
1.3
Control Unit
The control unit has following three mounting methods:
• Tabletop mounting: The unit is secured from the underside.
• Tabletop mounting with KB fixture: The unit is secured from the topside.
• Flush mounting
Mounting considerations
• Select a location where the unit can easily be operated.
• Locate the unit out of direct sunlight.
• Locate the unit away from places subject to water splash and rain.
• Select a location where shock and vibration are minimal.
• Select a mounting location considering the length of the cable.
• Referring to the outline drawings at the back of this manual, allow sufficient space
for maintenance and service.
• A magnetic compass will be affected if the unit is placed too close to the magnetic
compass. Observe the compass safe distances at the front of this manual to prevent
interference to a magnetic compass.
• For flush installations, select a location where the surface is flat.
1-12
Detailed view
Set the notches of the unit to
the screws.
Advertisement
Table of Contents
