Razor ECOSMART CARGO Owner's Manual page 7

ASSEMBLY AND SET-UP
headline
Adjusting the Front Seat Height
1
To adjust the height of the front
seat, open the quick-release lever on
the seat post.
Adjusting the Front Seat Position
Required Tool: 10 mm Wrench (included)
1
Using a 10 mm wrench, loosen
the two (2) lock nuts below the front
seat.
Inflating the Tires
The tires are inflated when shipped, but they invariably may lose some pressure between the point of manufacturing
and your purchase. Always inflate tires to the correct PSI before first time use.
Lower air pressure can result in a shorter ride time.
Periodically check tires. Reinflate when needed.
Remove the valve cap and using a
bicycle style tire pump equipped for
a Schrader-type valve, inflate the
tires to the correct PSI indicated on
the sidewall of the tire. Replace the
valve cap.
2
Slide the seat to the desired
position.
2
Adjust seat forward or back to the
desired position.
3
Lock the seat position by closing
the quick-release lever on the seat
post.
3
Using a 10 mm wrench, tighten the
two (2) lock nuts below the front seat
to lock the seat in position.
5 5
WARNING: Failure to
properly secure the quick-release
lever may cause the seat to
telescope up or down while riding
and may cause you to lose control
and fall.
WARNING: Failure to
properly secure the lock nuts on the
front seat may cause the seat to
move forward or back while riding
and may cause you to lose control
and fall.
WARNING: Do not use the
electric scooter for the first time
until you have inflated the tires to
the correct PSI. Failure to do so may
damage your electric scooter and
void your warranty.
WARNING: Do not
overinflate, as this could damage the
tires or wheels.
Note: The pressure air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate your
electric scooter tires, first make sure
the pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
overinflate the tires, release the
excess pressure immediately.