Removing Cartridge Group - ABB TPL65VA10 Operation Manual

8.5
8.5
CAUTION
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly

Removing cartridge group

Removing cartridge group
Remove insulation.

Disconnect oil lines in accordance with engine manufacturer's instruc-

tions.
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be en-
sured that the orifice plates that are specified for the turbocharger have
been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.

Loosen and remove sealing air line (56501) between compressor cas-

ing (72000) and variable turbine geometry module (56100).
Remove three studs (72029) at top.

Attach lifting device (90190) to compressor casing (72000), then fas-

ten and secure it to crane using lifting gear.
Unscrew nuts (61037).

Uniformly press apart compressor casing (72000) using three press-off

nuts (61090).
Slightly lift compressor casing (72000) and withdraw it.

Operation Manual / TPL65VA10 / VA30
8
8.5 Page 94