Table of Contents
Advertisement
5.5.2
WARNING
© Copyright 2016 ABB. All rights reserved.
Maintenance
Cleaning components mechanically
Turbine-end, non-rotating parts
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or
contact with them may be harmful to health.
Do not breathe in these substances and avoid contact with the skin.
Ensure proper ventilation.
Observe the information in the material safety data sheet for the op-
erating materials and supplies.
Comply with local legislation.
Wear safety goggles.
Wear safety gloves against mechanical risks.
Wear a respiratory mask to protect against gases.
Baked-on layers of contamination, for example from heavy fuel oil or
coked oil, occur at the turbine end. The following performance-relevant
parts can be cleaned according to the following description.
56001
Nozzle ring
63000
Turbine diffuser
Place contaminated parts in hot water or in a liquid such as carbon
remover, so that the contamination softens.
Brush off the contamination or remove it with a steam cleaner.
Repeat the soaking and brushing if necessary.
Completely remove any solvents from the parts in clean water.
Dry components completely.
Spray cleaned surfaces with penetrating oil. Do not spray the outer
surfaces of the turbocharger.
Dispose of contaminated water and cleaning agent in accordance with
the specifications in the safety data sheet.
Operation Manual / TPL65VA10 / VA30
5
5.5
Page 66
Advertisement
Table of Contents
