Download Print this page

Installation - Crown ETS-30 Installation & Operation Manual

Electric tilt skillets

Advertisement

Electric Tilting Skillets

Installation

U
NPACKING
Immediately after unpacking the steamer, check for possible shipping damage. If the steamer is found to be damaged,
save the packaging material and contact the carrier within 15 days of delivery.
Before installing, verify that the electrical service agrees with the specifications on the rating plate located on the left
side panel as you face the front of the braising pan. If the supply and equipment requirements do not agree, contact
your dealer or Crown Food Service Equipment Ltd.
Installation Instructions
Set skillet in place and level appliance using spirit level. Mark hole locations on floor through anchoring holes provided in
flanged adjustable feet.
Remove appliance and drill holes in locations marked on floor and insert proper anchoring devices.
Re-level the appliance, leveling the unit left to right and front to back.
Bolt and anchor appliance securely to the floor. Seal bolts and flanged feet with Silastic or equivalent compound.
Service Connections
All internal wiring for the skillet is complete.
Make service connections as indicated on page 4.
This must be a waterproof connection from incoming lines.
Ground skillet to terminal provided in control housing. A wiring diagram is provided and is located inside the control cover
panel.
If faucet is provided connect water supply and check for proper operation.
If this appliance is equipped with casters, the installation shall be made with flexible power supply conduit and
adequate means must be provided to limit the movement of the appliance without depending on, or transmitting
stress, to the electrical conduit; restraining means may be attached to the bracket near the entry of the power
supply connection on the appliance.
If the unit is also equipped with an optional water fill valve it too must be installed with a flexible water supply
tube, a quick disconnect and strain relief.
INSTALLATION & OPERATION MANUAL 10089 REV 4 (09/22)
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
WARNING
Installation
5
PAGE
OF12

Advertisement

loading

This manual is also suitable for:

Ets-40