Advertisement
I
NSTALLATION
Installation
U
NPACKING
Immediately after unpacking the steamer, check for possible shipping damage. If the steamer is found to be damaged,
save the packaging material and contact the carrier within 15 days of delivery.
Installation Instructions
1. The kettle must be installed in accordance with:
a) State and/or local codes.
b) In the USA, the National Electrical Code, ANSI/NFPA-70 (latest edition). In Canada, the Canadian Electrical
Code, Part 1, CSA Standard C22.1 (latest edition).
2. Position appliance on counter allowing sufficient rear clearance from wall to tilt freely and completely without obstruction.
3. Mark four corner locations of appliance base.
4. Remove appliance from counter and locate position of 4 holes as per Figure 1. Drill four 7/16" diameter holes.
5. Apply a continuous bead of Silastic or other equivalent sealant along the complete perimeter edge of the appliance base.
6. Use 5/16-18 Hex Cap Screws with suitable flat washers to bolt down. Screw length must be 1-1/4 long plus counter
top thickness.
7. Wipe off excess sealant.
8. A Control Box with power supply equivalent to Electrical Rating of appliance should be located conveniently nearby.
Electrical and grounding connections must comply with the applicable portions of the National Electrical
Code and/or other local electrical codes.
Disconnect electrical power supply and place a tag at the disconnect switch to indicate you are on the circuit.
9. A waterproof electrical connection from power supply to console housing must be provided.
10. Ground appliance to terminal provided inside console housing.
11. Turn power ON and check for proper operation.
Figure 1
6
PAGE
OF 20
Self-Generating Steam Jacketed Counter Tilting Kettle
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
ELECTRICAL GROUNDING INSTRUCTIONS
INSTALLATION & OPERATION MANUAL 10294 REV 1 (02/22)
WARNING
WARNING
Advertisement
