MSI MS-7067 User Manual page 17

9. Press down the load lever lightly
onto the load plate, and then se-
cure the lever with the hook under
retention tab.
11. Press the four hooks down to fas-
ten the cooler. Then rotate the lock-
ing switch (refer to the correct di-
rection marked on it) to lock the
hooks.
locking
switch
MSI Reminds You...
1. Confirm if your CPU cooler is firmly installed before turning on your
system.
2. Check the information in PC Health Status of H/W Monitor in BIOS
for the CPU temperature.
3. Do not touch the CPU socket pins to avoid damage.
4. Whenever CPU is not installed, always protect your CPU socket pins
with the plastic cap covered (shown in Figure 1) to avoid damage.
5. Please note that the mating/unmating durability of the CPU is 20 cycles.
Therefore we suggest that you do not plug/unplug the CPU too often.
10. Align the holes on the mainboard
with the heatsink. Push down the
cooler until its four clips get
wedged into the holes of the
mainboard.
12. Turn over the mainboard to con-
firm that the clip-ends are cor-
rectly inserted.
Hardware Setup
2 - 7