Table of Contents
Advertisement
Onboard Super IO Device
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select Disabled in this field. The settings are: Enabled and
Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial ports.
The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
Onboard Parallel Port Mode
SPP : Standard Parallel Port
EPP : Enhanced Parallel Port
ECP : Extended Capability Port
ECP + EPP: Extended Capability Port + Enhanced Parallel Port
Normal
To operate the onboard parallel port as Standard Parallel Port only, choose "SPP.
" To operate the onboard parallel port in the EPP mode simultaneously, choose
"EPP." By choosing "ECP", the onboard parallel port will operate in ECP mode
only. Choosing "ECP + EPP" will allow the onboard parallel port to support both
the ECP and EPP modes simultaneously.
Setting BIOS Function
3-17
Advertisement
Table of Contents
