Table of Contents
Advertisement
Press PgUp/<+> or PgDn/<-> to select Manual, None or Auto type. Note that
the specifications of your drive must match with the drive table. The hard disk
will not work properly if you enter improper information for this category. If
your hard disk drive type is not matched or listed, you can use Manual to define
your own drive type manually.
If you select Manual, related information is asked to be entered to the following
items. Enter the information directly from the keyboard. This information should
be provided in the documentation from your hard disk vendor or the system
manufacturer.
IDE HDD Auto-Detection
Primary/Secondary Master/Slave
Cylinder
Access Mode
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Drive A
This item allows you to set the type of floppy drives installed.
Press [Enter].
Settings are None, Auto, Manual.
Number of cylinders.
The settings are CHS, LBA, Large, Auto.
The formatted size of the storage device.
Number of cylinders.
Number of heads.
Write precompensation.
Cylinder location of the landing zone.
Number of sectors.
Setting BIOS Function
3-7
Advertisement
Table of Contents
