Advertisement
Table of Contents
IMPORTANT
1. Please ensure that the Autel IMMO tablet is connected to the Internet when using the All Keys Lost function.
2. After the function is completed, please restore the original vehicle circuit to avoid vehicle fault.
3. For other models, please check and follow the operation guides and wiring diagrams in their respective
menus.
4. Once connected, the G-BOX/APB112's firmware will be automatically updated as needed. Please wait until
the update is completed.
TOOLS YOU NEED
Toyota 8A Blade AKL Kit
Autel MaxiIM IMMO Tablet (IM508/IM608/MaxiSys IM)
G-BOX/G-BOX2
APB112 Smart Key Emulator
TOYOTA 8A BLADE AKL KIT
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Autel MaxiIM TOYOTA 8A BLADE KEY
Summary of Contents for Autel MaxiIM TOYOTA 8A BLADE KEY
- Page 1 IMPORTANT 1. Please ensure that the Autel IMMO tablet is connected to the Internet when using the All Keys Lost function. 2. After the function is completed, please restore the original vehicle circuit to avoid vehicle fault. 3. For other models, please check and follow the operation guides and wiring diagrams in their respective menus.
- Page 2 STEPS 1. Power on the tablet, tap [IMMO] on the tablet, and select one by one [Toyota] – [Manual Selection] – [Camry] – [2015-] – [Blade Key] – [Control Unit] – [Immobilizer (H 8A/8E)] – [All Keys Lost]. 2. Find the fuse box near the vehicle’s DLC, remove the IGN_NO.1 fuse from the designated fuse slot (see the picture below) on the fuse box, and connect the IGN FUSE to this fuse slot.
- Page 3 4. Remove the steering wheel cover, pull out the KSW_NO.1 ignition switch wire harness as shown below and connect the KSW wire harness to the ignition coil. 5. Connect the G-BOX to the 8A AKL cable and then to the vehicle’s DLC. Tap [OK] on the tablet to continue.
- Page 4 6. Insert a key blade (without chip) and turn ON the ignition. 9. The simulator key is successfully generated. 7. The tablet will read the critical data and ask you to confirm the key data. Data reading time varies from several seconds to several minutes, depending on the specific vehicles.
- Page 5 12. Tap [OK] to establish vehicle communication. 1) Turn OFF the ignition, remove APB112 and pull out the key blade. 2) Insert a key (with chip) and ensure the ignition is OFF. 14. Wait for 5 to 180 seconds. The key learning is completed when the immobilizer warning light is off.
Need help?
Do you have a question about the MaxiIM TOYOTA 8A BLADE KEY and is the answer not in the manual?
Questions and answers