Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Tenda HG7c
Summary of Contents for Tenda HG7c
- Page 1 Quick Installation Guide AC1200 Dualband Wi-Fi xPON ONT HG7c Package Contents • xPON ONT x 1 • Power adapter x 1 • Ethernet cable x 1 • User manual x 1 For product or function details, please go to www.tendacn.com to download the user guide.
-
Page 2: Get To Know The Ont
Get to know the ONT LED indicators LED indicator Color Status Description Solid on The ONT is powered on properly. Green The ONT is powered off or not powered on properly. Solid on The ONT is registered successfully. Green Blinking The registration is not completed (unregistered or registering). -
Page 3: Ports And Buttons
Ports & Buttons Port/Button Description Optical fiber port. You can find it on the bottom of the ONT, which is used to connect to a fiber cord. Power jack. Please use the included power adapter to connect the ONT to a power source. Gigabit LAN ports. - Page 4 1. Connect and register the ONT Caution, laser DO NOT look directly at the PON port when the device is powered on, as well as the terminal of the indoor fiber cord, to prevent any harm to your eyes. Connect the ONT as shown in the figure. The ONT automatically adapts to the fiber access type. Wait until the PON LED indicator lights solid on, then the ONT is registered successfully.
-
Page 5: Router Mode
Router mode Option 1 Access internet over PPPoE Step 1: Log in to the web UI Connect a LAN port of the ONT to a computer using an Ethernet cable, or connect your smartphone to the Wi-Fi network of the ONT using the SSID (Wi-Fi name) and Key (Wi-Fi password) on the bottom label. - Page 6 PON WAN This page is used to configure the parameters for PONWAN nas0_0 Enable VLAN: VLAN ID: 802.1p_Mark Channel Mode: PPPoE Admin Status: Enable Disable Connection Type: INTERNET MTU: 1492 Enable IGMP-Proxy: Enable MLD-Proxy: IP Protocol: IPv4 PPP Settings: UserName: Password: Continuous Type:...
- Page 7 Option 2 Access internet over DHCP Step 1: Log in to the web UI Refer to Step 1: Log in to the web UI in Option 1 Access internet over PPPoE under Router mode to log in to the web UI of the ONT. Step 2: Set up a WAN connection Choose WAN >...
-
Page 8: Bridge Mode
Bridge mode Tips: When the ONT is set to Bridge mode, please con gure internet settings based on ISP requirements. Access internet over PPPoE Connect a LAN port of the ONT to the WAN port of a router using an Ethernet cable. Connect your computer to a LAN port of the router using an Ethernet cable. - Page 9 Q1: I cannot log in to the web UI by visiting 192.168.1.1. What should I do? A1: Try the following solutions: • Ensure that the ONT is powered on properly (the PWR LED indicator is solid green). • If you use a wireless device, such as a smartphone, to configure the ONT: - Ensure that your smartphone has disabled mobile data and is connected to the Wi-Fi network of the ONT.
- Page 10 Q4: I cannot find the 5 GHz Wi-Fi signal of the ONT on my wireless device. What should I do? A4: Try the following solutions: • Check whether your wireless device supports 5 GHz Wi-Fi network. Only devices supporting 5 GHz network can find and connect to the 5 GHz Wi-Fi network.
Need help?
Do you have a question about the HG7c and is the answer not in the manual?
Questions and answers