MSI K8MM-ILSR User Manual page 46

MS-6741 Micro-ATX Mainboard
USB Wakeup From S3
This item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state. Settings: Enabled, Disabled.
Power Management/APM
Setting to Enabled will activate an Advanced Power Management (APM) device to
enhance Max Saving mode and stop CPU internal clock. Settings: Disabled, Enabled.
Suspend Time Out (Minute)
After the selected period of system inactivity, all devices except the CPU shut off.
Settings: Disabled, 1, 2, 4, 8, 10, 20, 30, 40, 50, 60.
Display Activity
These items specify if the BIOS will monitor the activity of the specified hardware
peripheral or component. If set to Monitor, any activity detected on the specified
hardware peripheral or component will wake up the system or prevent the system
from entering the power saving modes. Settings: Monitor, Ignore.
Thermal Active Temperature
If the CPU temperature reaches the upper limit preset in this setting, the warning
mechanism will be activated. This helps you to prevent the CPU overheating problem.
Power Button Function
This feature sets the function of the power button. Settings are:
On/Off
Suspend
After AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Power Off
Power On
Last State
Set WakeUp Events
Press <Enter> and the following sub-menu appears.
3-14
The power button functions as normal power off button.
When you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before power
failure or interrupt occurred.