Husqvarna 535RX Operator's Manual page 13

8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To install the saw blade
WARNING:
around the saw blade nut. Make sure that
the blade guard is correctly installed. Always
use protective gloves.
1. Attach the drive disc (B) to the output shaft.
2. Turn the blade shaft until one of the holes in the
drive disc aligns with the hole in the gear housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Install the saw blade (D) and the support flange (F)
to the output shaft.
5. Install the saw blade nut (G).
Note:
The saw blade nut has a left hand thread.
6. Turn the socket wrench counterclockwise to tighten
the locknut. Make sure that the torque of the locknut
is 35-50 Nm (3.5-5 kpm). Hold the shaft of the socket
wrench as near the blade guard as possible.
G
B
1069 - 008 - 31.10.2022
There is a risk of injury
F
D
C
a) Make sure that you operate the socket wrench in
the identified area when you loosen or tighten the
saw blade nut.
To install the blade guard
CAUTION:
guard for the blades. Refer to
on page 29 .
1. Remove the bracket (H).
2. Attach the adapter (I) and bracket (J) with the 2
screws (K).
3. Attach the blade guard (A) to the adapter with the 4
screws (L).
H
Only use the approved
Accessories
J K
I
L
A
13