Polaris PRO XD Owner's Manual page 142

MAINTENANCE
BATTERY REMOVAL
Improperly connecting or disconnecting battery cables can result in an
explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the
battery, always connect the negative (black) cable last.
1. Remove the storage bin under the passenger seat to access the battery.
2. Disconnect the black (-) battery cable first. Disconnect the red (+) battery
cable last.
3. Remove the battery hold-down strap.
4. Lift the battery out of the vehicle.
BATTERY INSTALLATION
Using a new battery that has not been fully charged can damage the battery and
result in a shorter life. It can also hinder vehicle performance. Follow the battery
charging instructions before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the fully charged battery in the battery holder. Make sure the positive
terminal is toward the driver's side of the vehicle.
3. Coat the terminals with dielectric grease or petroleum jelly.
4. Connect and tighten the red (+) cable first. Connect and tighten the black (-)
cable last.
5. Install the hold-down strap.
6. Reinstall the storage bin and seat.
BATTERY STORAGE
Whenever the vehicle is not used for a period of three months or more, remove
the battery from the vehicle, ensure that it's fully charged, and store it out of the
sun in a cool, dry place. Check battery voltage each month during storage and
recharge as needed to maintain a full charge.
Battery charge can be maintained by using a POLARIS Battery Tender charger
or by charging about once a month to make up for normal self discharge.
Battery Tender can be left connected during the storage period, and will
automatically charge the battery if the voltage drops below a predetermined
point. See the Polaris Products section for the part numbers.
140
WARNING
TIP