Polaris PRO XD Owner's Manual page 138

MAINTENANCE
WHEEL INSTALLATION
WARNING
Improperly installed wheels can adversely affect tire wear and vehicle
handling, which can result in serious injury or death. Always ensure that all
nuts are torqued to specification. Do not service axle nuts that have a cotter pin
installed. Your dealer can assist.
1. Place the transmission in PARK.
2. Place the wheel on the hub with the valve stem toward the outside and
rotation arrows on the tire pointing toward forward rotation.
3. Attach the wheel nuts and washers and finger-tighten.
4. Carefully lower the vehicle to the ground.
5. Torque the wheel nuts to specification.
POWER STEERING UNIT (IF EQUIPPED)
If your model is equipped with
power steering, frequently clean the
areas around and on the power
steering unit to allow proper cooling.
e
Clean these areas thoroughly.
LIGHTS
Poor lighting can result in reduced visibility when driving. Headlight and taillight
lenses become dirty during normal operation. Clean lights frequently and
replace burned out lamps promptly. Do not operate this vehicle at night or in low
light conditions until the headlight is replaced. Always make sure lights are
adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from
your skin leaves a residue, causing a hot spot that will shorten the life of the
lamp.
HEADLIGHT BULB REPLACEMENT
1. Remove the hood from the front cab.
2. Locate the bulb on the back side of the headlight housing.
136