MSI E7210 Master-FARM User Manual page 29

MS-9149 ATX Server Board
IDE DMA transfer access
Setting to Enabled will open DMA bus master and execute DMA action in
DOS, which will make the data transferrin g faster. Settings: Di sab led,
Enabled.
On-Chip Primary/Secondary PCI IDE
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Choose Enabled to activate each channel separately.
IDE Primary/Secondary Master/Slave PIO
The four items allow you to set a PIO (Programmed Input/Output) mode for
each of the fou r IDE dev ices that the onb oard IDE interface su pports.
Modes 0~4 provid e increas ed performance. In Auto mo de, BIOS aut o-
matically determines th e best mo de for each IDE device.
IDE Pri mary/S econdary Master/ Slave UDMA
Ultra DMA implementation is possible only if your IDE device supports it
and your operatin g env iron ment contains a DMA driv er. If b oth y our
hard drive and software support Ultra DMA 33 (or higher), select Auto t o
enable BIOS support.
**On-Chip Serial ATA Setting**
On-Chip Serial ATA
This setting allows you to detemine how the RAID controller on the south
bridge is going to switch to SATA controller. Options: Manual, Disabled
or Aut o. When set to [Auto ], BIOS will auto matically swt ich RAID to
SATA and v ice versa. If [Disabled] is selected, only SATA controller will
be enabled.
Serial ATA Port 0/ 1 Mode
Select a compatible mode for Port 0 and Port 1 from Award setting to the
chipset settings:
1. Primary Master
=> Compatible Mo de with Serial ATA Port 0 set t o Primary Master
2. Primary Slave
=> Compatible Mo de with Serial ATA Port 0 set to Primary Slave
3. Secondary Master
=> Compatible Mod e with Serial ATA Port 0 set to Secondary Master
3-18
4. Secondary Slave
=> Compatible Mo de with Serial ATA Port 0 set to Secondary Slave
5. Logical Primary
=> Co mpatible Mode wit h only Serial ATA Enabled and Port 0 set to Pri-
mary Master
6. Logical Secondary
=> Compat ible Mode with on ly Serial ATA Enab led and Port 0 set to Sec-
ondary Master
7. Enhance Mo de Port 0 ( Tertiary Master )
=> Enhance Mode with Port 0 set to Native Mode Master
8. Enhance Mode Port 1 ( Quaternary Master )
=> Enhance Mode with Port 1 set to Native Mode Master
Onboard Device
Press <Enter> to enter the following sub-menu screen.
USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) con-
troller and you have USB peripherals. Setting options: Enabled, Disabled.
USB 2.0 Controller
Set to Enab led if you need to us e any USB 2.0 device in the o perat ing
system that does not support or have any USB 2.0 driver installed, such as
DOS and SCO Unix. Setting options: Disabled, Enabled.
BIOS Setup
3-19