Cisco SX10 User Manual page 4

3. Camera Control
While on a call, there may be capability to control the camera on both sides of the call. Camera control
on your side of the call is called
A. Near End Camera Control
i. While on a call or not on a call (as shown here),
move the cursor up to the upper right corner to the
'Camera' icon. Press 'OK'
iii. You may now adjust the pan, zoom and tilt of the
camera. Use 'Increase'/ 'Decrease'
control to adjust the zoom and the cursor controls to
adjust the pan and tilt. Press
B. Far End Camera Control
i. Navigate to 'Participants'
corner and press 'OK'
list of the participants will then appear.
iii. To control the far end camera, navigate to
'Camera' and click 'OK'
'Near End' and on the other side of the call is called
on the remote control.
controls on the remote
'Back' to exit the menu.
in the upper right
on the remote control. A
on the remote control.
'Far End.'
ii. The 'Camera' icon will now appear. Press
again on the remote control.
ii. A menu showing a list of the participants on
the call will now appear. Navigate to the
participant whose camera you want to control
and press 'OK' on the remote control.
A submenu will now appear.
Note: if you select 'Drop'
be disconnected from the call.
iv. Adjust the pan, tilt and zoom and use
or 'Back' on the remote control to exit.
'OK'
that participant will
'OK'
August 2019