Lighting Instructions - Napoleon BIPRO 500 Manual

Lighting Instructions

Igniter
WARNING!
WARNING!
supply valve.
Main Burner
1. Open grill lid.
2. Push and turn any main burner knob
slowly to the high position. If the pilot
lights, continue to push down on the
control knob until the burner lights and
then release.
3. If the pilot does not ignite, then
immediately turn the control knob back
to the 'off' position and repeat step 2
several times.
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob
to the 'off' position and wait 5 minutes
for any excess gas to dissipate. Either
repeat steps 2 and 3 or light with a
5. If lighting the unit with a match, clip
the match into the supplied lighting
rod. Hold the lit match down through
the grill and sear plate while turning the
corresponding burner valve to high.
WARNING!
turned off prior to turning the cylinder on, only small flames and low heat will be achievable.
WARNING!
N415-0378 OCT 23.17
Left Left Centre
Burner Burner
Open lid
Ensure all burner controls are in the off position. Slowly turn on the gas
Rear Burner Lighting
Lighting
2. Remove warming rack.
3. Turn rear burner control to high
igniter button until burner lights, or
match.
5. If ignition is not immediate, turn
burner control off. Wait 5 minutes.
The propane cylinder is equipped with an excess flow device. Unless all burners are
Do not use rear burner while operating main burner.
Rear
Right Centre Right
Burner
Burner Burner
(if equipped)
1. Open grill lid.
2. Turn side burner control to high position.
position. igniter button until burner lights, or light
4. Press and hold
immediate, turn burner control off. Wait 5
light by match.
Repeat.
Lights
Off Position
Side Burner Lighting
(optional)
1. Open burner cover.
3. Press and hold
by match.
4. If ignition is not
minutes. Repeat.
www.napoleongrills.com
7
EN