Table of Contents
Advertisement
7.
Insert the hex-head bolt (5/16 x 5-1/2 inches)
through hole 8 mm (5/16 inch) in the inboard-lift
bracket (long flanges), bed structure, and the
outboard bed-lift bracket (short flanges) as
shown in
Figure
6.
Figure 6
1. Locknuts (5/16 inch)
2. Hole 8 mm (5/16 inch)
8.
Secure the bolt with the flange nut (5/16 inch)
hand-tight
(Figure
3. Hex-head bolt (5/16 x
5-1/2 inches)
6).
3
Installing the Switch
Parts needed for this procedure:
1
Switch
Fuse (15 A)—machine serial number 411599999 and
1
before only
Machine Serial Number 411599999
and Before
1.
Disconnect the negative-battery terminal from
the battery.
2.
Remove the plug from the dash panel, to the
right of the steering column and above the key
switch
(Figure
g025010
Note:
If the hole in the dash is in use, measure
over 13 mm (1/2 inch) and cut another 21 x
35 mm (27/32 x 1-15/32 inches) rectangular
opening in the dash. Ensure that you do not
damage any existing components behind the
dash when cutting the hole.
1. Plugged hole
2. Bed-lift switch
3.
Plug the bed-lift switch into the harness
connector in the dash.
Note:
Do not install the switch.
4.
Install a new fuse (15 A) into the open slot in
the fuse block.
5
7).
Figure 7
3. Cut the new hole (if
required).
g001324
Advertisement
Table of Contents
