Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Lift the lever on either side of the cargo bed and
lift the bed up
(Figure
1. Lever
2. Prop rod
1).
Figure 1
3. Detent slot
5.
Pull the prop rod into the detent slot to secure
the bed
(Figure
WARNING
A raised bed could fall and injure persons
that are working beneath it.
• Always use the prop rod to hold the
bed up before working under the bed.
• Remove any load material from the
bed before raising it.
1. Detent slot
6.
Remove the 4 flange nuts securing the latch-rod
brackets to the underside of the bed
g014860
1. Bed
2. Latch rod
7.
Remove and retain the latch rod and latches.
3
2).
Figure 2
2. Prop rod
(Figure
Figure 3
3. Flange nut
g029622
3).
g024927
Advertisement
Table of Contents
