Installing The Windshield - Toro Security Cage Kit Installation Instructions Manual

6

Installing the Windshield

Parts needed for this procedure:
1 Dual-tab mount
2 Side-tab mount
1 Top-tab mount
6 Rivet
1 Lower-windshield assembly
1 Upper-windshield assembly
13 Bolt (5/16 x 1-1/2 inches)
13 Backup washer
13 Rubber bushing (0.31 inch long)
13 Rubber bushing (0.56 inch long)
13 Nut (5/16 inch)
1. Dual-tab mount
2. Side-tab mount
3. Top-tab mount
4. Rivet
Procedure
Refer to
Note:
that the seam is positioned on the bottom of the frame.
1.
2.
3.
4.
Figure 7
5. Lower windshield assembly
6. Upper windshield assembly
7. Bolt (5/16 x 1-1/2 inches)
8. Backup washer
7
Figure 7 as you perform the following steps.
Ensure that the upper windshield is installed so
Install the dual-tab mount between the upper
and lower windshield frame on the ROPS.
Use 2 rivets to secure the 2 side-tab mounts
into the holes provided in the 2-post ROPS
extension pillar cover.
Use a rivet to secure the top-tab mount into the
hole provided in the 2-post ROPS extension
front panel.
Install the lower and upper windshield
assemblies with 13 bolts (5/16 x 1-1/2 inches),
13 backup washers, 13 rubber bushings (0.31
inch long), 13 rubber bushings (0.56 inch long),
and 13 nuts (5/16 inch).
9. Rubber bushing (0.31 inch long)
10. Rubber bushing (0.56 inch long)
11. Nut (5/16 inch)
12. Seam
g211834