Assembly And Cabling - LD DAVE G4X Series User Manual

ASSEMBLY AND CABLING

DANGER:
Always place the speaker system in a suitable location on a sufficiently stable, level and
horizontal surface. Make sure that the speaker system cannot fall off the edge of a stage
(e.g. due to vibration). There is a risk that equipment that has not been set up and positioned
correctly will fall over or down. This can cause serious injury or death.
For optimal sound distribution of the bass, position the subwoofer centrally between the two satellite
speakers . If a central position is not possible, the subwoofer can alternatively be positioned side-
A
ways . Use the M20 flange on the top of the subwoofer to attach a distance rod. In both cases, select
B
the DSP preset corresponding to the set-up variant (MODE SELECT, left symbol).
The DAVE 12, DAVE 15 and DAVE 18 G4X satellites have a dual tilt flange with 0° and 5° tilt. Use the 0°
flange with a standing audience and adjust the height of the bottom edge of the satellites to approxi-
mately the head height of the audience.
Use the 5° tilt flange with a seated audience. Pay attention to the maximum permissible load and
height of the stands and spacer rods used (stands and spacer rods optionally available).
The entire electronics with DSP and power amplifiers are located in the subwoofer of the DAVE G4X
speaker systems, therefore a connection between subwoofer and satellites only has to be made using
suitable speaker cables (optionally available, recommendation min. 2 x 1.5 mm²).
A
8