Operation; Overheating Protection - Malmbergs 85 500 00 Instruction Manual

1. drill 2 holes in the wall, one per wall bracket, and
fasten the wall brackets with suitable screws.
2. Place the lower edge of the radiator on the lower
part of the wall brackets (pic. 1).
3. Pull out the upper part of the wall bracket (pic. 2)
and secure the radiator so that its upper and lower
edges rest in the slots in the wall bracket.

OPERATION

1. Connect the heater to the mains.
2. Set the switch to position 1.
3. Set the thermostat to the highest setting until the radiator is really hot.
When the temperature in the room has reached the desired level, turn the
thermostat down until the light goes out, which means that the heating will
be switched off temporarily. Heating will then be regulated automatically by
the thermostat, and the temperature in the room will be maintained at the
desired level. Note: The coldest operating temperature is -15°C.

OVERHEATING PROTECTION

The radiator is fitted with an automatic cut-out to prevent overheating (e.g. if
the heater gets covered). The radiator will restart again as soon as it has cooled
down.
14
2