Installing The Feet - Malmbergs 85 500 00 Instruction Manual

CONNECTION
Heaters with voltage of 230V is connected with cable and plug to an earthed
socket outlet (230V).
Heaters with voltage of 400V is connected according to the wiring diagram
below. Please note that only a qualified electrician is allowed to perform a
permanent installation.
Wiring Diagram (400V)
L1
L2
E Earth

INSTALLING THE FEET

Note: Only radiators with voltage of 230V can be free standing.
1. Turn the heater upside down.
2. Fasten the feet with the screws, according to the picture below.
3. Turn the heater back to its feet.
4. Wait five minutes before using the heater.
B
12
Thermostat
Circuit card
Switch
B
Heating element
Overheating protection
A
A
B