Correct Placement Of The Holders - paramondo Pergorama 4000 Installation Instructions Manual

Always fit the specified number of consoles.
Additional consoles can be attached on request.
However, the manufacturer does not state any higher / different loads (higher wind load) of the product in
this case.
The choice of the most appropriate fixing component depends on the type of base material and on the
physical condition of the latter. It is therefore the assembler's place to check the condition of the base ma-
terial before fixing the awning. We suggest using plugs or metric screws.
T
T = 400 mm ÷ 500 mm ± 50 mm
Note:
Note: Hx goes to the bottom of the wall bracket. If you were already thinking about the installation height
when taking the measurements, take the value Hx noted at the time.
L
T
Hx

Correct placement of the holders

Ordering width
Hx
This figure shows only the left
holder in detail for assembly.
www.paramondo.de
71
T