Table of Contents
Advertisement
switch01 (config) # show interfaces mgmt0
Interface mgmt0 status:
Comment:
Admin up:
yes
Link up:
yes
DHCP running:
yes
IP address:
192.168.1.100
Netmask:
255.255.255.0
IPv6 enabled:
yes
Autoconf enabled:
no
Autoconf route:
yes
Autoconf privacy:
no
DHCPv6 running:
no
IPv6 addresses:
1
IPv6 address:
fe80::202:c9ff:fe63:b55a/64
Speed:
1000Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
Interface source:
physical
MTU:
1500
HW address:
00:02:C9:63:B5:5A
RX bytes:
968810197
RX packets:
10982099
RX mcast packets:
0
RX discards:
0
RX errors:
0
RX overruns:
0
RX frame:
0
switch01 (config) #
Step 6. Check the software version embedded in your system, using the command 'show version'.
Compare this version to the latest version that can be retrieved from NVIDIA support site. To
upgrade software, please refer to the
Disable Dynamic Host Configuration Protocol (DHCP)
DHCP is used for automatic retrieval of management IP addresses.
If a user connects through SSH, runs the wizard and turns off DHCP, the connection is immediately
terminated, as the management interface loses its IP address. In such a case, the serial connection
should be used.
<localhost># ssh admin@<ip-address>
Mellanox Onyx (MLNX-OS) Switch Management
Password:
Mellanox Switch
Mellanox configuration wizard
Do you want to use the wizard for initial configuration? yes
Step 1: Hostname? [my-switch]
Step 2: Use DHCP on mgmt0 interface? [yes] no
<localhost>#
Remote Connection with NVIDIA Onyx (MLNX-OS)
Once the network attributes are set, you can access the CLI via SSH or the WebUI via HTTP/ HTTPs.
To access the CLI, perform the following steps:
1.
Set up an Ethernet connection between the system and a local network machine using a
standard RJ45 connector.
TX bytes:
1172590194
TX packets:
10921755
TX discards:
0
TX errors:
0
TX overruns:
0
TX carrier:
0
TX collisions:
0
TX queue len:
1000
NVIDIA Onyx (MLNX-OS) User
Manual.
53
- Quick Links:
- Sn2201 Ordering Part Numbers
Hide quick links:
Advertisement
Table of Contents
