Table of Contents
Advertisement
Series 6 - R640 Physical Hosts
The following figure shows Series 6 - R640 host (port 0) connected to PowerVault (port
1 in top row of ports) using a mini-to-mini SAS cable.
The PERC H840 card for the R640 is installed in slot #1. This means that:
Port 0 is on the left and port 1 is on the right on the R640.
l
You must attach the cable to the R640 with the connector's blue tab on the top.
l
You must attach the other end the cable to the PowerVault with the connector's blue
l
tab on the top.
You know if the cable is properly connected when you hear a click as the cable locks
l
into place and see the green port light illuminate on the R640.
41
PowerVault (Dell MD1400 - 16TB) Setup Guide
Install PowerVault on Core Appliance Used as a Hybrid
Advertisement
Table of Contents
