Dell MD1400-16TB Setup Manual page 29

4. For the Series 6 - R640 host, you can connect two to four PowerVaults to the RAID
controller if you are encrypting the PowerVaults.
a. Connect the Primary Port 1 of the first PowerVault to Port 0 of the Decoder RAID
controller.
b. Daisy chain up to three additional PowerVaults to the first PowerVault.
The following figure shows you how to connect multiple PowerVaults to an NetWitness
Series 6 hosts. You can attach up to four PowerVaults. You connect the first PowerVault
to Port 0 of the Series 6 - R640 host and daisy-chain PowerVaults two, three, and four to
the first PowerVault.
5. When you finish the cabling, ensure that the PowerVault is powered on and then power on
the host.
29
PowerVault (Dell MD1400 - 16TB) Setup Guide
Install PowerVault with Encryption on a Series 6 R640 Host