Insert A Microsd Card - Honeywell CN80 Series User Manual

Heater Setting
Fast monitoring interval
Slow monitoring interval
Disable temperature
Blanking
Update
Default

Insert a microSD Card

You can use a microSD card to increase file storage capacity or to install software.
Honeywell recommends the use of Single Level Cell (SLC) industrial grade
microSD or microSDHC memory cards with the computer for maximum
performance and durability.
Caution: Always power off the computer before attempting to install or
Warning: If you have a CN80 NI model certified for use in hazardous
Note: Format the memory card before initial use.
1. Save your files and close any open applications.
2. Press and hold the Power button until the options menu appears.
3. Tap Power Off.
4. Release one end of the hand strap.
5. Slide the battery latch to the right.
28
Description
Set sampling interval time (seconds) used once the computer
detects cold storage entry. Cold storage entry is defined by the
Heater enabled temperature.
Set sampling interval time (seconds) used once the computer
detects cold storage exit (defined by DeltaT value).
Set the temperature limit (°C) that triggers turning off the heater.
Tap check box to enable or disable heater operation during
scanning.
Tap to apply changes made to settings.
Tap to set the Heater settings back to their default values.
remove a card.
locations, read About the optional Dust Cover
CN80 Mobile Computer Series User Guide
on page 7.