Canarm AgSystems FGC Series Operation Instructions And Parts Manual

FGC SERIES
FIBERGLASS EXHAUST FANS
oPeratIon InstructIons and Parts manual
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY
Rotating parts, (pulleys, shafts and belts) on fans should not be exposed. Where these components are not protected by ductwork, cabinets
or covers, appropriate guards should be employed to restrict exposure to rotating parts. Access doors should not be opened with the fan
operating to avoid foreign objects being drawn into the system. On initial start-up, a careful inspection should be carried out to ensure no
foreign material is present which could become airborne in the system.
Read installation and operation instructions carefully before attempting to install, operate or service Canarm FGC Series Exhaust Fan. Failure
to comply with instructions could result in personal injury and/or property damage. Retain instructions for future reference.
CONE INSTALLATION
1. Slide one piece of the cone into the groove on a
second piece of the cone.
Note: Point fan parts upwards to make installation
easier.
2. Drill a hole large enough for the included hardware
through both pieces using the divot on the inside of the
cone as a guide. One at each end and one in the
centre.
3. Fasten the 2 cone pieces together in the centre using
the hardware provided.
4. If you are assembling the 54" FGC Fiberglass Fan,
repeat steps 1-3 to attach a 3rd piece of the cone.
5. You should now have only 1 piece of the cone not
attached. Take the partially assembled cone from the
earlier steps and slide the shorter, grooved end over
the opening on the housing.
6. Line up one of the drilled holes in the cone with a
pre-drilled hole in the housing and fasten.
Note: you may need to make the hole in the housing
larger
7. Attach the cone using the other pre-drilled holes in the
housing. A drill will be needed to fasten each cone
section on its center edge to the housing.
8. Attach the final piece of the cone.
InstallatIon or Product Problems? do not return to store of Purchase.
contact canarm servIce at 1-800-265-1833 (canada) 1-800-267-4427 (u.s.a.)
1-800-567-2513 (en franÇaIs) monday to frIday 8:00 - 5:00Pm e.s.t.
fGc-m-07_20_22 Page 1 of 2