Supermicro A3SEV-2C-LN4 User Manual page 69

SATA and RST Configuration
SATA Controller(s)
This feature enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Enabled and Disabled.
SATA Mode Selection
Use this feature to select the SATA mode. The default is AHCI.
SATA0 - SATA2
Hot Plug
This feature designates the SATA port specified for hot plugging. Set this feature to Enabled
for hot-plugging support, which allows you to replace a SATA disk drive without shutting down
the system. The options are Enabled and Disabled.
Spin Up Device
When the value of an edge detect or the value of an image binary (pixel) of a device is from
0 to 1, select Enabled to allow the PCH to start a COMRESET initialization sequence on this
device. The options are Enabled and Disabled.
SATA Device Type
Use this feature to specify if the SATA port should be connected to a Solid State drive or a
Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
Trusted Computing

The motherboard supports TPM 2.0. The following Trusted Platform Module (TPM) information
will display if a TPM 2.0 module is detected:
•
Vendor Name
•
Firmware Version
Security Device Support
If this feature and the TPM on the motherboard are both set to Enabled, onboard security
devices will be enabled for TPM support to enhance data integrity and network security.
Please reboot the system for a change on this setting to take effect. The options are Disable
and Enable.
69
Chapter 4: BIOS