Uplift Desk STR041 Assembly Instructions

3-Drawer Narrow Square File Cabinet
SKU: STR041
Package Contents
File Cabinet Pencil Tray
(qty 1) (qty 1)
To prevent tipping, the max load of the top 2 drawers is 10 lbs each and the max load of the bottom drawer
is 35 lb.
Keys (qty 2) Flange Lock
Nut (qty 4)
Hanging Folder
Bar (qty 1)
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
Support Caster Split Lock
Pin (qty 1) Washer (qty 4)
Front Locking
Casters (qty 2)
STEP 1
A. After unboxing the File Cabinet, unlock the
drawers and remove the casters, Pencil Tray, and
hardware from the top drawers.
B. Grab a friend to help you turn the File Cabinet
upside down on a clean blanket or carpet to
protect the top surface from scratches. Be
careful to keep the drawers from opening while
turning the File Cabinet over.
C. Pull out the bottom drawer, exposing the top
and bottom sides of the caster mounting holes
located at the 4 corners of the bottom surface.
D. Put a Split Lock Washer on the stem of a Front
Locking Caster and place the stem through one
of the front holes.
E. From the inside of the bottom surface, thread a
Flange Lock Nut onto the Front Locking Caster
stem. Use one 14 mm Flat Wrench to hold the
integrated caster nut and tighten the Flange
Lock Nut with the other 14 mm Flat Wrench.
F. Repeat steps 1.D and 1.E for the remaining
casters, making sure the other Front Locking
Caster is installed in the other hole at the front
of the File Cabinet, and the 2 Rear Casters (non-
locking) are installed in the back.
14 mm Flat
Wrench (qty 2)
Rear Casters Support
(qty 2) Caster (qty 1)