Array Solutions PowerMaster Series Manual page 3

Federal Communications Commission
(FCC) Statement
Note: This equipment has been tested and found to comply with the
limits for Class B digital devices, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Industry Canada Compliance Statement
This Class B digital apparatus meets the requirements of the Canadian
Interference-Causing Equipment Regulations.
Avis de conformité à la réglementation d'Industrie Canada
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement
sur le matériel brouilleur du Canada.
PowerMaster Series RF Wattmeter
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
•
from that to which the receiver is connected.
Consult a qualified radio/TV technician for help.
•
Properly shielded and grounded cables and connectors must be used
in order to meet FCC emission limits. Array Solutions is not
responsible for any radio or television interference caused by using
other than recommended cables or connectors or by unauthorized
changes or modifications to this equipment. Unauthorized changes or
modifications could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interferences, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Responsible Party: Array Solutions, Telephone 972 203 2008
Array Solutions Rev 3.5 Feb 20, 2007
3