Generac Power Systems Magnum MTT25 Operating Manual page 40

• Check that winch cables are in good condition
and are centered on each pulley. DO NOT use a
cable that is kinked or starting to unravel.
• Check that the safety pins for the mast lock rod
and mast lock bar are present and secured with
a chain. Check that the spring located in the mast
lock bar is not broken or missing. Check the
operation of the mast lock bar.
• Check the wheel lugs. Refer to
Lights for Transportation" on page
• Check the coolant level daily. Refer to the engine
operator's manual for coolant recommendations
and proper mixture.
○ Coolant is checked visually by inspecting the level in coolant overflow jug located near the radiator.
○ Normal operating level is between the full and add markings on the overflow jug known as normal range.
○ WHEN ENGINE IS STOPPED AND COMPLETELY COOL, coolant may be added directly to the coolant
overflow jug.
• Check the oil level daily. Refer to the engine operator's manual for the proper viscosity grade of oil, including
special operating conditions such as a change in season or climate.
○ DO NOT start the unit if the engine oil level is below the add mark on the dipstick.
○ Normal operating level is in the cross-hatch pattern between the full and add markings on the dipstick.
○ Add oil only if oil level is below the add mark on the bottom of the cross-hatch pattern on the dipstick.
DO NOT OVERFILL crankcase.
• Check the fuel level.
• If the unit is connected to a remote start or transfer switch, make sure the remote switch is also off and tagged.
Note: If the engine was run out of fuel or the fuel tank was drained, it may be necessary to bleed the fuel lines. Refer
to the engine operator's manual supplied with the unit.
"Removing the
37.
PROPER MAST CABLE ROUTING
00131
39