Hoover HHP55CA011 User Manual page 6

GB
1.1 MULTI SENSOR SYSTEM
Thanks to the Multi Sensor System your product will continuously monitor the indoor air condition in terms of PM10, PM2.5 and Volatile Organic
Compounds (GAS).
Each time you switch your product on, the Multi Sensor System will start analyzing the indoor air quality and the Air Quality LED Ring will
illuminate with different colors representing real time air quality conditions.
Air Quality LED Indoor Air
Ring Color
GREEN
YELLOW Satisfactory
ORANGE
RED
* In Pollen Allergy mode, PM 10 values that trigger the air quality level will be lower to minimize the risk for allergic people.
1.2 CARBON MONOXIDE (CO) ALERT
H-Purifier is equipped with an alert system that will constantly monitor the indoor air for Carbon Monoxide (CO).
When the Carbon Monoxide alarm is activated, the AIR Quality LED Ring, Infomation & CO Alert button will flash red simultaniously and an
audible alarm will sound. The alarm will remain in operation until the Carbon Monoxide (CO) concentration has reduced to below 50 ppm unless
silenced manually by pressing the CO Alert Button for 3 seconds.
The CO Alert LED shows the working condition of the CO sensor. It appears in green color when the CO sensor is in normal condition, in yellow
color when the sensor is malfunctioning or exceeds its working life and in red color when CO alert is activated.
You can test if the alarm is working properly by pressing the CO Alert Button for 3 seconds, a loud buzzer sound will last for 5 seconds if the alarm
works properly.
2. PREPARING YOUR H-PURIFIER
2.1 INSTALL THE FILTER [Fig. 1]
Before using your H-Purifier product you will need to remove the Filter from its protective packaging:
• Remove the Air Inlet Cover from your product, grip the two Air Inlet Cover Handles and pull from the product. [Fig. 1a]
• Remove the plug from the Transportation Location and release the cord from the Storage Hook. [Fig. 1b]
• Unlock the Filter Release Switch. [Fig. 1c]
• Remove the Filter from your product and remove the outer packaging. [Fig. 1d,e]
• Refit the Filter into your product. [Fig. 1f]
• Lock the Filter Release Switch. [Fig. 1g]
• Refit the Air Inlet Cover to your product. [Fig. 1h]
Fig. 1
2.2 INSTALL THE DIFFUSER BOTTLE [Fig. 2]
To prepare your H-Purifier product for the Diffuser function:
• Remove the Diffuser Cover from the product. [Fig. 2a]
Remove the Diffuser Unit from the Diffuser Cover. [Fig. 2b]
•
• Remove the bottle of H-Essence or H-Biotics from the packaging and remove the cap. [Fig. 2c]
• Preserve the cap for future storage use.
Tightly screw the bottle on the Diffuser unit. [Fig. 2d]
•
• Refit the Diffuser Unit into the Diffuser Cover. [Fig. 2e]
Refit the Diffuser Cover into the product. [Fig. 2f]
•
Fig. 2
6
PM 10 value*
Quality μg/m³
Excellent 0-50
50-80
Poor 80-160
Very poor ≥ 160
PM 2.5 value GAS VOC
μg/m³ Level
0-25 L1
25-50 L2
50-100 L3
≥ 100 L4
Air Quality
LED Ring
CO Alert Button
CO Alert LED