Hoover HHP55CA011 User Manual page 10

GB
5. STORAGE OF YOUR H-PURIFIER
1. Switch off the H-Purifier and unplug the power cord.
2. Clean all the internal and external surfaces of the H-Purifier and the external layer of the Filter.
3. Remove the bottle from the diffuser. Refit the original cap onto the bottle and store it to protect from direct light. Clean the surfaces of diffuser
unit and Diffuser Cover. Make sure there is no residual of H-Essence or H-Biotics on any surface of the H-Purifier.
4. Ensure all components are dry.
5. Remove the Air Inlet Cover [Fig. 17a], reel in the power cord by pulling on the cord [Fig. 17b], fit the cord into the Storage Hook and fit the
plug into the Transportation Location. [Fig. 17c,d] Refit the Air Inlet Cover [Fig. 17e]
6. Store the H-Purifier in a cool dry place.
Fig. 17
6. ALERTS & SOLUTIONS
The following codes may appear during use. [Fig. 18]
Fig. 18
Alert on product
"CLEAN FILTER"
"REPLACE FILTER"
"FILTER MISSING"
"PM SENSOR ERROR"
CO Alert LED is yellow
/
"TEMP. & HUMI.
SENSOR ERROR"
"PAUSE"
ATTENTION: If any of these failures persist, contact your local Hoover representative. DO NOT try to disassemble the H-Purifier by yourself.
10
REPLACE
FILTER
Alert
Alert in APP
Pre-Filter cleaning Suggest to clean the external layer of the
Alert Filter.
Filter replacement
Suggest to replace the Filter.
Alert
Error: an error
occurred with the
Filter is not in position or is not correctly
air purifier, please
locked
check possible
solutions
/ PM sensor malfunctioning
Error: an error
occurred with the
CO sensor malfunctioning or CO sensor
air purifier, please
exceeds its working life.
check possible
solutions
Error: an error
occurred with the
air purifier, please Motor failure
check possible
solutions
Temperature and humidity sensor
/
malfunctioning
Diffuser working will pause when Air
/
Quality LED Ring is not green.
Alert Description Solution
1. Clean the external layer of the Filter.
2. Reset the alert by holding INFORMATION
button for 3 secs.
Refer to 4.1 FILTER MAINTENANCE
1. Replace the Filter.
2. Reset the alert by holding INFORMATION
button for 3 secs.
Refer to 4.1 FILTER MAINTENANCE
1. If filter is not present, put it back.
2. If filter is in position, check whether the Filter
Release Switch is on LOCK status.
Refer to 2.1 INSTALL THE FILTER
PM sensor failure or sensor wire has not been
connected well, please call service center to fix.
Call service center to fix.
Motor failure or motor wire has not been
connected well, please call service center to fix.
Temperature and humidity sensor failure or
sensor wire has not been connected well,
please call service center to fix.
No need action. Diffuser working will resume
when Air Quality LED Ring is green.