Table of Contents
Advertisement
Operating The Product
WARNING:
FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN INJURY
AND/OR DAMAGE.
Manual Controls
The Opti-myst Manual controls are located on the base of the appliance.
(See Fig.2 for Manual Control lay out)
Switch 'A':- Controls the electricity supply to the Fire.
Note: This switch must be in the 'ON' ( I ) position for the Fire to operate with or without heat when
activated.
Switch 'B':- Press
once to turn on the flame effect. This will be indicated by an audible "beep".
Although the main lights operate immediately it will take a further 45 seconds before the flame effect
starts.
Press
to put fire into standby mode. This will be indicated by one "beep".
Remote Control
The remote control is packed with 2 AA batteries in a bag. Lift off the battery cover on the back of the
remote control and insert the batteries taking note of the polarity.
The remote control has already been paired to your product during factory assembly. In the unlikely
event that the remote control disconnects from the product, or you obtain a spare remote control, you
will need to complete the pairing process:
1.
With the product plugged in press switch A to the ON (I) position. You should hear an audible
beep
2.
Press and hold 'Button 6' until PAIR appears on the display
3.
Bring the remote control close to the product where the receiver is
4.
The product will start to beep and blink
5.
Press 'Button 6' to complete the pairing process. The product will go into standby mode.
Switching on the appliance
Press and hold the ENTER button for 3 seconds to activate the remote control. FIRE will be displayed
and ON will be blinking. Press ENTER to swtich on the appliance. To turn off the appliance press MENU
so that FIRE is blinking, press ENTER twice.
Adjust the Flame Setting
With the remote control activated press once. FIRE will be blinking on the display. Press ENTER. The
current flame setting will be displayed F1-F6. Press the UP and DOWN buttons to adjust the setting.
After you have selected your flame setting press BACK twice to exit the menu and return to the home
screen.
Switching on the Heat
With the remote control activated press MENU once. FIRE will be blinking on the display. Press ADV
once, HEAT will be blinking. Press ENTER. The current heat setting will be displayed OFF LO HI. Press
the UP and DOWN buttons to adjust the setting. After you have selected your flame setting press ENTER
Setting the Thermostat
The temperature shown on the display is the room temperature set point. This is the temperature that
the heater will maintain during the heating periods. If the room temperature is above this temperature
then the heater will not operate. The heater leaves the factory with this temperature set at 15ºC which
. See Fig 2
5
Advertisement
Table of Contents
