Table of Contents
Advertisement
Operating The Product
WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN INJURY
AND/OR DAMAGE.
Please Note: The Remote Control is packaged with the bag this Instruction Manual is stored in. The battery for the remote
is already installed, a protective plastic slip must be removed from the remote control before operation.
Operating Instructions - See Figure 5
Icon Display
Funtion
Power /
A
-
Standby
F1 / F2 /
F3
B
Flame
P
Pulsing
-
Off
Sleep
C
Timer
Low
Heat
D
High
Heat
Cool
Blow
-
Off
E
30
Temp Up
Temp
F
18
Down
Flame
-
G
Colour
Top-light
H
-
Fuel Bed
6
Description
Press Once to turn the product 'ON'.
Press a second time to put the product into 'STANDBY'
(When returning from 'STANDBY' mode the product will return to previous settings unless
the product has been unplugged, in which case it will reset to factory settings)
'FLAME EFFECT' button this turns the flame effect ON or OFF independently of the
products other features.
This Button will change the brightness of the flame effect. There are 3 brightness
settings shown as F1, F2, F3.
This setting is set by pressing the Flame Up button once more after F3. This will cause the
brightness of the flame effect to cycle randomly, creating a flickering effect.
If the flame effect is turned off, but the heater is ON, the display will activate and remain
active to read the set temperature and indicate if the product is on LOW HEAT/ HIGH
HEAT/ COOL BLOW.
Press multiple times to change the 'SLEEP TIMER' in 0.5 hr increments from 0.5
hr to 8.0 hr before turning off. The remaining time on the 'SLEEP TIMER' displays.
(This icon is Green in colour)
'HEAT' button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH HEAT,
COOL BLOW and OFF. The heat setting will be indicated by an icon in the display.
When the flame effect is 'ON' the display will turn off after 5 seconds, however if the
heater is being used independently of the flame effect. The low heat or high heat icon
will appear continuously in the display.
This setting will run the heater at 'LOW HEAT' this setting will be indicated by the 'LOW
HEAT' icon and the letters 'LO' appearing in the display. To adjust the temperature
setting the Temp Down or Temp Up buttons described below must be used.
(This icon is Orange in Colour)
This icon in the display indicates 'HIGH HEAT' this setting will be indicated by the 'HIGH
HEAT' icon and the letters 'HI' appearing in the display. To Adjust the temperature setting
the Temp Down or Temp Up buttons described below must be used.
(This icon is Red in Colour)
This icon in the floating display indicates 'COOL BLOW' this setting will be indicated by
the 'COOL BLOW' icon and the letters 'CB' appearing in the display.
(This icon is Blue in Colour)
This switches the heater and blower 'OFF', no icon will be displayed in the display. Note
the blower will run for 5-10 seconds after being turned off, this is to ensure the product
cools down safely.
Press multiple times to increase the heater temperature in 2
temperature that can be set 30
When High Heat is selected, the letters 'HH' appear in the display, this means the heat
will remain ON continusously and is not controlled by the thermostat.
Press multiple times to lower the heater temperature in 2
temperature that can be set is18
Press to turn ON/OFF the coloured accents within the flame effect.
Press to turn ON/OFF the Top light illuminating the fuel bed.
0
C.
0
C increments. The lowest
0
C.
0
C increments. The highest
Advertisement
Table of Contents
