King Quest VQ4100 Owner's Manual page 19

4. Run coax from the antenna unit to the roof edge, then along edge to location where coax will be
fed into the vehicle. If installing an optional second receiver, run second coax to location where it
will enter the vehicle. Secure (both) coax to roof every 12-18 inches (see below).
5. Drill 3/4" hole through the roof and into the cabinet where receiver is stored. Feed coax down
through hole. Seal opening with roof-compatible sealant so that it is completely waterproof
(inside and outside of the 3/4" hole). Repeat for second coax if present.
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
Installer is responsible for determining proper roof-compatible sealant.
All holes for cables and fasteners must be sealed so they are completely waterproof.
6. Make interior connections shown on page 6 or 7.
OPTIONAL: INSTALLATIONS WITH
CABLE ENTRY COVER:
Fasten cable entry cover to roof with
appropriate sealant and roof fasteners.
IMPORTANT!
Installer is responsible for
determining proper fasteners.
Mounting holes, perimeter of cable
entry cover and cable opening of
cable entry cover must be sealed
so they are completely waterproof.
Page 17