King Quest VQ4100 Owner's Manual page 18

IF INSTALLED, REMOVE THE (3) RUBBER FEET FROM THE BOTTOM OF THE
ANTENNA UNIT. DO NOT ROOF MOUNT ANTENNA UNIT WITH FEET IN PLACE.
MAKE SURE YOU READ AND UNDERSTAND ALL OF THE IMPORTANT POINTS ON
PAGE 13 BEFORE BEGINNING THE INSTALLATION.
2. Apply roof-compatible sealant to roof around entire area where fasteners will penetrate the roof.
Mount the antenna unit using the (4) mounting holes. After mounting unit, seal fastener heads
with roof-compatible sealant.
There are two coax ports on the back of the antenna unit. The one labeled "MAIN" MUST be connected to the KING
power inserter. The AUX port can be used for an additional receiver, or for DIRECTV SWM installations. Review the
wiring diagrams on pages 6-7 before routing your coax.
3. Connect one end of the RG-6 coax cable to the MAIN port and tighten connection (see below).
DO NOT OVER-TIGHTEN.
If using a second receiver, connect one end of second RG-6 coax (sold separately) to the AUX
port. Tighten connection. DO NOT OVER-TIGHTEN.
Page 16
ANTENNA UNIT MOUNTING
COAX ROUTING
IMPORTANT!
Coax connections should be snug.
DO NOT OVER-TIGHTEN!