King Quest VQ4100 Owner's Manual page 16

In the KING Quest box:
Antenna Unit
50' RG-6
Coax Cable
You will also need a drill and drill
bits, roof-compatible sealant, and
appropriate fasteners to install all
components and wiring.
Many RVs are prewired with RG-6 coax cable for satellite antennas. Contact the manufacturer of your RV or your local
dealer to verify where this cable is located.
If prewired, run the existing coax cable from the prewired location in the roof to the antenna unit. When choosing the
antenna unit location, make sure the prewiring will reach the antenna unit.
1. Select an area on the roof for the antenna unit and the location where the wiring will enter the
vehicle through the roof to the satellite receiver inside using the following criteria:
• A shorter distance between the antenna unit and the satellite receiver is most desirable.
• Make sure you have enough room to mount the antenna unit.
• The antenna unit should be mounted on the center line of the vehicle, and not tilted more than
2 degrees in any direction.
• There must be no line of sight obstructions. Air conditioning units, other antennas, and storage
areas that are too close to the antenna unit may prevent the satellite signal from reaching the
antenna unit.
• Mount the antenna unit with the handle to rear of the vehicle.
Page 14
ITEMS YOU WILL NEED
ANT REC
Power Inserter
with Power Supply
Short Coax Cable
(3) Rubber Feet
Do not use rubber feet.
If installed on antenna unit,
remove before mounting.
The CE2000 Cable Entry Cover (sold
separately) provides a watertight seal
where cables penetrate the roof (see the
satellite antenna accessories page at
kingconnect.com for more information).
ANTENNA UNIT LOCATION
Additional Items (sold separately):
Programming
Subscription
Cable(s)
DIRECTV Receiver*
*Some DIRECTV receivers require additional
components to enable satellite signal reception (page 7).
Visit kingconnect.com/support for additional receiver
compatibility information.
TV
KC1358