Table of Contents
Advertisement
NLSet up and connect
WARNING
Risk of injury!
When used on a plinth, the device can
tip over.
The device feet for commissioning
▶
on a plinth must be absolutely
with the fixings
→
Page 30 confirm from the
manufacturer.
PAY ATTENTION!
Freezing residual water in the device
can damage the device.
Do not place and use the device in
▶
frost-sensitive places or outdoors.
If the device is tilted more than 40°,
residual water can run out of the
device and cause material damage.
Carefully tilt the device.
▶
Transport the device upright.
▶
installation site
Plinth
Floor with wooden
beams
14
To demand
The device with
locking lips
→ Page 30
to confirm.
Place the device
guess at a wa-
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
installation site
kitchen
on a wall
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
Remark:Keep the screws of the
transport locks and the sleeves for
later transport
→ Page 51 .
Pull the hoses out of the holders.
1.
To demand
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
No snakes and
mains connection
between wall and
device clamping
man.
Advertisement
Table of Contents
