Installing The Colonydoc-It; Installing The Hardware - UVP ColonyDoc-It Instruction Manual

ColonyDoc-It Imaging Station

Installing the ColonyDoc-It

Installing the Hardware

Set the ColonyDoc-It Imaging Station on a
level surface.
Plug in one end of the power cord to the back
of the ColonyDoc-It Imaging Station and the
other end into a power outlet. To maintain
safety at all times, ensure that the unit is not
hard to disconnect at the location chosen.
Turn on the ColonyDoc-It by switching the I/0
switch to I located at the back of the station.
Plug one end of the USB cord to the back of
the ColonyDoc-It and the other end into a USB
port in the computer.
Removing the Doors
The ColonyDoc-It doors can be removed by
hand-loosening the two thumbnuts on the
inside of each door.
9