Product Description; Getting To Know The Product Components - Tec-Innovation INNOMAKE CLIP User Manual

2.

Product description

Scope of delivery:
1x InnoMake Clip

1x charger with micro USB plug

1x User manual

Not included are adapters for other aids, such as long cane, rollator, wheelchair, etc. (These
must be ordered separately.)
In addition, you can use the InnoMake App as an accessory to the InnoMake Clip to
customize the obstacle detection feedback to your specific needs. The InnoMake App is
available in the App Store for iPhones and iPads. The app is not mandatory for the use of
InnoMake products.
Information on the InnoMake App can be found in
the App Instructions for Use and in the QuickGuide stored in the InnoMake App.
On our website www.tec-innovation.com, you can have the app instructions for use, as well
as these instructions for use, output with the help of a read-aloud program.

2.1. Getting to know the product components

InnoMake Clip with ultrasound sensors
We refer to the side facing away from the body as the front. The opposite surface of the
InnoMake clip is the back. The front side faces in the direction of walking during use and can
also be recognized by the fact that our company logo, a dot with three waves, is raised in
the area below the two openings.
Ultrasonic sensors are installed in the two openings on the front. These two sensors
transmit and receive ultrasonic waves as long as the InnoMake Clip system is active.
During use of the InnoMake Clip, the ultrasonic sensors point in the respective walking
direction and detect obstacles located in front of the user.
An ultra-bright LED is installed between the two ultrasonic sensors, which can be activated
on the device to improve visibility - especially in the dark.
The activation of the LED is described in
Viewed from the front, there is a push button on the left side surface of the clip. If you press
this button, the lid of the micro USB socket installed there is lifted on the opposite right side
surface. The lid can only be pushed out of its anchoring by pressing this button. In this
pressed-out state, the lid can be turned to the side to free the micro-USB socket. The micro
USB socket for a micro USB plug is intended for charging the InnoMake Clip together with
the charger supplied by us.
TDIMC1_4_User Manual_IMC-1.1.0_EN
section 2.3, as well as in more detail in
section 4.7.
5