Safety Instructions - Tec-Innovation INNOMAKE CLIP User Manual

Occurrence
Activate
intelligent mode
(starting with
firmware version
1.2.1)
Deactivate
intelligent mode
(starting with
firmware version
1.2.1)
Battery empty (1.
Warning tone)
Device is
overheated
(2. warning
tones)

5. Safety instructions

 The InnoMake Clip may only be used within the scope of its intended purpose as a
support for safe and personal locomotion. The use of the feedback is also intended
exclusively for the perception of the distance measurement within the scope of the
intended purpose.
The non-manipulated delivery condition of the InnoMake Clip is a prerequisite for

appropriate use. Modification or manipulation of the InnoMake Clip is not permitted.
 The InnoMake Clip must not come into contact with acidic liquids.
If the ambient noise level is high, the sound signals may be too quiet. In such a situation,

it is absolutely necessary to pay increased attention to the vibration signals of the
InnoMake Clip.
 If unusual heat development is detected, the unit must be switched off immediately.
As soon as the feedback from the InnoMake Clip can no longer be clearly perceived, the

dealer must be contacted.
Failure to observe alarms can lead to bodily injury or even damage to property,

especially if the device overheats, if obstacles are ignored
The InnoMake Clip must not be dried with hot air, e.g., a hair dryer, but only in the air at

room temperature.
TDIMC1_4_User Manual_IMC-1.1.0_EN
Acoustic
Keystroke
signal
2x long low tones, 1x
4x short
short low tone
2x long and
1x short low tone
3x equal, then
3x descending tones
(like „Power off")
2x changing tones
(siren), then
3x descending tones
(like „Power off")
Vibratory
LED-Signal
signal
2x short
impulses
followed by 1
long impulse
3x short
impulse
Permanent
impulse
Permanent
impulse
see
section
4.7
4.10
16