Toshiba SUPER MMY-MAP0501T8 Instruction Manual page 21

Change of indoor address from wired remote controller
• To change the indoor address in individual operation (Wired remote controller : Indoor unit = 1 : 1) or
group control (When the setup operation with automatic address has finished, this change is available.)
<Procedure> (Operation while air conditioner stops)
1
Push simultaneously
(The firstly displayed unit No indicates the header unit in group control.)
2
In group control, select an indoor unit No to be changed by
(The fan of the selected indoor unit is turned on.)
3
Using the setup temp.
4
Using the timer time
want to change.
5
Push button.
SET
6
Using the
UNIT
Repeat the procedure
7
After the above change, push
8
If it is acceptable, push
+ +
SET
CL
/
/ buttons, change the displayed setup data to a data which you
button, select the unit No. to be changed at the next time.
4 6
to and change the indoor address so that it is not duplicated.
button to confirm the changed contents.
UNIT
button to finish confirmation.
4
8
1
5
Operation procedure
1 2 3
buttons for 4 seconds or more.
13
buttons, set to the item code.
CODE No.
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
4 5 6 7
18
button.
UNIT
2, 6, 7
3
8
End