Driver Installation For Windows Xp; Windows Xp Wireless Zero Configuration - Linksys WPC55AG User Manual

Driver Installation for Windows XP

1. Windows XP will automati-
cally detect the Adapter.
Click the radio button next to
Install the software auto-
matically (Recommended).
Insert the Setup Wizard CD-
ROM into your computer's
CD-ROM drive. Then click
the Next button.
Important for Windows XP users: Do NOT run the Dual-Band
Wireless A+G Notebook Adapter Setup Wizard. If the Setup Wizard
runs automatically after the Setup Wizard CD-ROM has been insert-
ed, click the Exit tab.
2. After Windows has finished
installing the driver, click the
Finish button.
You have now completed the driver installation for
the Dual-Band Wireless A+G Notebook Adapter. To configure the
Adapter, proceed to the next section, "Windows XP Wireless
Zero Configuration."
6
Figure 4-3
Figure 4-4

Windows XP Wireless Zero Configuration

Important for Windows XP users: Windows XP has a built-in con-
figuration tool. Use the Windows XP Wireless Zero Configuration (in
the system tray at the bottom of your screen) to configure the Adapter.
1. A f t e r i n s t a l l i n g t h e
Adapter, the Windows
X P W i r e l e s s Z e r o
Configuration icon will
appear in your computer's
system tray. Double-click
the icon.
Note: These instructions are for Windows XP with Service Pack 1
installed.
If you have not installed Service Pack 1, select the network you want,
and click the Connect button. If the network has WEP encryption
enabled, enter the WEP key in the Network key field, and then click the
Connect button.
2. The screen that appears will show any available wireless network. Select the
network you want.
If this network has WEP
encryption disabled, go to
Step 3.
If this network does not
have WEP encr yption
enabled, then Figure 4-6
will appear. Make sure
the box next to Allow me
to connect to the selected
wireless network, even
though it is not secure is
checked. Then click the
Connect button, and go
to Step 4.
Figure 4-5
Figure 4-6
7