Chapter 5: Hardware Installation; Chapter 6: Driver Installation And Configuration For Windows Xp; Overview; Driver Installation For Windows Xp - Linksys WPC11 User Manual

Chapter 5: Hardware Installation

Important for Windows 98SE, Me, and 2000 users: You must run
the Setup Wizard to install the software before installing the hardware.
Important for Windows XP users: You must install the PC Card's
hardware before installing the software.
1. Turn off your notebook PC.
2. Locate an available PC Card slot on your notebook PC.
3. With the PC Card's
label facing up, as
shown in Figure 5-1,
slide the PC Card
completely into the
PC Card slot.
4. Restart your note-
book PC.
5. Windows will begin copying the driver files to your computer. (Windows
2000 users may see a digital signature screen. This is normal. Click Yes to
continue, and then click the Finish button to end the hardware detection
process.) If Windows asks you for the original Windows CD-ROM, insert
the CD-ROM, and direct Windows to its proper location (e.g., D:\).
If your PC is using Windows 98SE, Me, or 2000, proceed to the next sec-
tion, "Chapter 7: Using the WLAN Monitor for Windows 98SE, Me, and
If your PC is using Windows XP, proceed to "Chapter 6: Driver
Installation and Configuration for Windows XP."
9
Instant Wireless
®
Figure 5-1
2000."
Series Wireless-B Notebook Adapter
Chapter 6: Driver Installation and
Configuration for Windows XP

Overview

After inserting it into your notebook, you will install the driver and configure
the Adapter.

Driver Installation for Windows XP

1. Windows XP will automatically detect the PC Card. Insert the Setup CD-
ROM into the CD-ROM drive. From the screen shown in Figure 6-1, click
the radio button next to Install the software automatically
(Recommended). Then, click the Next button.
Figure 6-1
10